• ATA.jpg

Aquablend eSQX Touch Free - Active Sense Point of Use Thermostatic Wall Mixer with 230mm Spout

Aquablend eSQX is Australia's first and most technically advanced touch free point of use thermostatic mixer solution delivering touch free controlled temperature heated water. Beneath outlet infra-red sensor activation is designed for general hand hygiene within health care and food preparation facilities. Designed for effective reduction of Legionella risk. Features flush cycles and smooth bore spout design. The point of use TMV also minimises warm water legs and is AS4032.1 WaterMark certified. Adjustable temperature range for user comfort. AHFG Type A and B healthcare basin compatibility. Smart, durable easy-clean chrome surfaces and sealed face plate minimises egress of moisture into wall cavity and contaminated air flow from wall cavity into sterile areas.

Key features

  • Smooth bore tubular spout designed to minimise bacteria growth
  • 12-hour flush cycle eliminates stagnation in water supply lines greatly reducing the risk of bacteria growth
  • Potentially contaminated air is elminated from the water stream with laminar flow controlled spout
  • Low voltage 6V battery operated or 12V mains supply
  • Back and front of wall components are separate order codes and can be supplied separately to meet construction needs
  • Face plate removes to access integral isolation/check valves, strainers and inspection ports for TMV servicing requirements
  • Products

    Order code Aquablend eSQX Touch Free - Active Sense Point of Use Thermostatic Wall Mixer with 230mm Spout
    ATABC2L3
    Front of Wall Component with 8Lpm Laminar Flow (Pairs with ATM620 back of wall component)
    ATABC2L5
    Front of Wall Component with 6Lpm Laminar Flow (Pairs with ATM620 back of wall component)
    ATABC2L6
    Front of Wall Component with 4Lpm Laminar Flow (Pairs with ATM620 back of wall component)
    ATAMC2L3
    Front of Wall Component with 8Lpm Laminar Flow (Pairs with ATM621 back of wall component)
    ATAMC2L5
    Front of Wall Component with 6Lpm Laminar Flow (Pairs with ATM621 back of wall component)
    ATAMC2L6
    Front of Wall Component with 4Lpm Laminar Flow (Pairs with ATM621 back of wall component)
    Note: Due to Voltage variation the Battery front must be matched with ATM620 Battery In wall component. Mains powered front must be match with ATM621.
  • Dynamic Inlet Pressures* 20 - 500 kPa (For optimum operation it is recommended that the hot and cold water supply pressures be balanced within +/- 10%)
    Static Inlet Pressures Maximum 1000kPa For testing purposes/system commissioning
    Hot Temperature Supply Range 55-85 C
    Cold Temperature Supply Range 5-25 C
    Minimum Temperature Differential (between hot supply and the outlet temperature) 10 C
    Adjustable Thermostatic Temperature Range* 35-46 C (+/-2)
    Minimum Flow Rate 2L/min
    * Enware products are to be installed in accordance with the Plumbing Code of Australia and AS/NZS3500. NOTE: Enware Australia advises: 1. Due to ongoing Research and Development, specifications may change without notice. 2. Component specifications may change on some export models.
  • ATA Line Drawing
  • Document type File type
    Brochure eSQX Aquablend Electronic Sequential Thermostatic Mixer
    Installation guide pdf
    BIM and 3D Files
Email Us